Hemera Multi-Parameter Gas Analyser – H₂S, CH₄, CO, CO₂, O₂ (biogas)

Hemera’s biogas configuration brings the five parameters that matter most in anaerobic digestion and biomethane upgrading into a single G800 analyser. Hydrogen sulphide is measured by interference-free UV FTLS spectroscopy, with methane, carbon dioxide, carbon monoxide and oxygen handled by complementary sensors in the same unit. One controller, one sample system and one set of outputs simplify integration, and an ATEX/IECEx explosion-proof version is available for hazardous areas.

  • H₂S, CH₄, CO, CO₂ and O₂ from one compact unit; up to eight channels possible
  • UV FTLS H₂S measurement unaffected by methane, CO₂ or moisture
  • Complementary sensing technologies combined under a single controller
  • Ranges configured to raw biogas, upgraded biomethane or engine-feed duty
  • Wall-mounted, 19-inch rack or ATEX/IECEx explosion-proof enclosures for Zone 1 or 2
  • 4–20 mA, relay alarm and RS485 Modbus outputs for plant SCADA
  • Low maintenance with optional automatic calibration
  • Two-year parts and labour warranty
Typical parametersH₂S, CH₄, CO, CO₂, O₂
Maximum channelsUp to 8 parameters per enclosure
H₂S measurementUV FTLS spectroscopy (example range 0–100 ppm, 1 ppm detection limit, ≤10 s)
Measurement rangesCustomised on request
EnclosuresWall-mounted or 19″ rack (safe area); explosion-proof ATEX/IECEx Zone 1 or 2
Sample conditions0–2 L/min, <2 bar, 5–35 °C
Display8.5″ TFT colour touchscreen
Outputs4–20 mA isolated, programmable relays, RS485 Modbus
Power100–240 VAC 50/60 Hz or 24 VDC, <20 W typical (60 W max)
Explosion-proof enclosureCopper-free aluminium, IP66, 413×488×320 or 640×370×278 mm
  • Anaerobic digestion and biogas plants
  • Biomethane upgrading and grid injection
  • CHP engine protection
  • Landfill gas monitoring
  • Process optimisation and regulatory compliance