Gas composition can change as it passes through a reactor, purification unit or recovery system. Measuring it at each stage helps operators spot changes in feed quality, check whether a process is performing as expected and verify that the finished gas meets its specification. These measurements are used in chemical manufacturing, industrial gas production and gas treatment and recovery plants.
What needs to be measured?
Process gas composition. Measuring gases such as hydrogen (H₂), carbon monoxide (CO), carbon dioxide (CO₂) and methane (CH₄) at the inlet and outlet helps operators assess how well a reaction or separation process is working. The gases and concentration ranges depend on the process.
Gas purity and trace impurities. Even small amounts of moisture, oxygen or other contaminants can affect product quality or downstream equipment. For example, in recovered CO₂, operators may measure several trace impurities before releasing the gas for its intended use.
Gas treatment performance. Comparing readings before and after scrubbers or other treatment stages helps operators check removal efficiency and spot when contaminants such as ammonia (NH₃) or hydrogen chloride (HCl) begin to pass through.
Process vents and exhausts. Monitoring selected gases at vents or stacks helps operators investigate changes in emissions during start-up, normal operation or process upsets.
Multi-gas FTIR analysers can measure several infrared-active compounds in one sample, while tunable diode laser analysers target selected gases. Sampling and instrument selection depend on the gas composition, expected concentrations and whether the sample is hot, wet or corrosive.
Explore AQA’s range of fixed and portable multi-gas analysers, laser-based instruments and gas sampling systems below.
MCerts and TÜV Certified { EN 15267-4:2024 | EN 12619:2013 | QAL1 (EN 14181} the OneFID is a cutting-edge Heated Flame Ionization Detector (HFID) featuring a proprietary, patented injection system that allows for the simultaneous measurement of Total Hydrocarbons (THC), methane (CH₄), and non-methane hydrocarbons (NMHC) using a single detector. This innovative design simplifies system architecture, reduces operational complexity, and ensures exceptional measurement accuracy, long-term reliability, and full regulatory compliance for industrial emissions monitoring applications.
Multicomponent FTIR gas analyser that quantifies many gases at once from a single infrared spectrum. 0.5 cm-1 resolution, 5 m optical path and heated cell options, offered in 19-inch rack, portable and wall-mounted versions.
Tunable diode laser analyser for low-interference, low-ppm measurement of CH4, CO2, HCl and NH3. Available as wall-mount, 19-inch rack or portable, with heated sampling options for hot emission streams.
For monitoring: Acetylene, Hydrogen, Methane, Propane, TVOCs. Single analog remote sensor for flexible location monitoring
Sampling of PAH’s with Filter/Condenser Method and adsorbing trap on the wet gas in accordance with Standards EN 1948-1, CEN/TS 1948-5 and US EPA Method 23

