Hemera COD, BOD, TSS, pH & Conductivity Analyser

This configuration of Hemera’s multi-parameter water analyser is the one most often specified for treatment works. Chemical and biochemical oxygen demand and suspended solids are measured optically by UV-visible spectroscopy, so there are no digestion reagents or waste to handle, while pH and conductivity come from integrated potentiometric probes. All five readings share one sample system, one controller and one set of outputs, with ranges set to the plant’s licence conditions.
  • COD, BOD, TSS, pH and conductivity from a single wall-mounted unit
  • Reagent-free optical COD (CODeq), BOD and TSS measurement by UV-visible spectroscopy
  • Integrated potentiometric pH and conductivity probes
  • Up to eight channels available, so turbidity, nutrients or TOC can be added later
  • Ranges configured to inlet, process or final-effluent duty
  • 4–20 mA, relay alarm and RS485 Modbus outputs for plant SCADA
  • Wall-mounted safe-area or ATEX/IECEx explosion-proof enclosure
  • Low maintenance with no consumable chemistry for the optical channels
Typical parametersCOD, BOD, TSS, pH, conductivity
Maximum channelsUp to 8 parameters per enclosure
Measurement methodsUV-visible spectroscopy (COD, BOD, TSS); potentiometric probes (pH, conductivity)
Measurement rangesCustomised on request
Sample conditions0–2 L/min, <2 bar, 5–35 °C
EnclosuresWall-mounted (safe area); explosion-proof ATEX/IECEx Zone 1 or 2
Standard enclosureSS316L, 430/570/900 × 340 × 195 mm, approx. 20 kg, IP54 (IP65 optional)
Display8.5″ TFT colour touchscreen
Outputs4–20 mA isolated, programmable relays, RS485 Modbus
Power100–240 VAC 50/60 Hz or 24 VDC, <20 W typical (60 W max)
  • Wastewater treatment works inlet and outlet monitoring
  • Industrial effluent discharge compliance
  • Biological treatment process control
  • Trade effluent monitoring
  • Storm overflow and river quality monitoring