Hemera Total Nitrogen (TN) Analyser

The Hemera TN Analyser measures the three inorganic nitrogen species that make up total nitrogen in wastewater and displays each one alongside the TN sum. Two methods are offered: the standard version reads nitrite and nitrate directly in the liquid by UV FTLS spectroscopy while ammonium is measured in the gas phase, and the full gas-phase version converts all species for the lowest detection limit. Both are immune to turbidity, colour and salinity and respond in under a minute.
  • Reports NH₄⁺, NO₂⁻, NO₃⁻ and total nitrogen from one instrument
  • Patented UV FTLS method with no interference from turbidity, TSS, colour or salinity
  • Method 1 (liquid + gas-phase): 1 mg/L detection limit, ≤2 % FS accuracy
  • Method 2 (full gas-phase): 0.1 mg/L detection limit, ≤1 % FS accuracy
  • Response time of one minute or less
  • Minimal reagent use and low maintenance
  • Wall-mounted L800 enclosure or ATEX/IECEx explosion-proof version for Zone 1 or 2
  • 4–20 mA, relay alarm and RS485 Modbus outputs
ParametersTN, NH₄⁺, NO₂⁻, NO₃⁻
Measurement methodsUV FTLS spectroscopy (liquid + gas-phase) or full gas-phase UV FTLS
Example range0–100 mg/L (custom ranges on request)
Accuracy≤2 % FS (method 1); ≤1 % FS (method 2)
Repeatability±2 % FS (method 1); ±1 % FS (method 2)
Detection limit1 mg/L (method 1); 0.1 mg/L (method 2)
Response time≤1 min
EnclosuresWall-mounted (safe area); explosion-proof ATEX/IECEx Zone 1 or 2
Outputs (L800 platform)4–20 mA isolated, programmable relays, RS485 Modbus
Power (L800 platform)100–240 VAC 50/60 Hz or 24 VDC, <20 W typical
  • Nitrification / denitrification control in biological treatment
  • Wastewater discharge compliance
  • Industrial effluent monitoring
  • Eutrophication control in receiving waters
  • Protection of downstream equipment